3 reasons to monitor the performance of the expansion tank cover

3 reasons to monitor the performance of the expansion tank cover Few people know exactly why there is a bulge in the pressure tank. But such a small detail can greatly delay the life of a spare part. So if you don't have a stethoscope, then a stick will do ... Few people know exactly why there is a bulge in the pressure tank. However, if you open the cover and look at the pressure gauge, it should be tilted a little, and not remain in its original position for a long time. If the valve in the gas tank is damaged, it will not help to fill it. To do this, you will need to remove the branch pipe from the gas tank, and insert a hose directly into the hole. The hose should be lowered into the tank so that it enters the tube of the gas pedal. If successful, the procedure of pumping the ejector hose into the tank can be performed independently, and without removing the gas pedal from the vehicle. However, this procedure of pumping the hose into the tank from the gas pedal will have its own nuances. For example, the method of pumping the hose into the tank from the gas pedal differs from the method of pumping the nozzle into the Kenwood fuel filter. When using a pump in a tubeless tire, you need to follow the same basic principles as with the use of a nozzle in a tubeless tire. This means that you should pump the hose before inserting it into the tube of the gas pedal. If the hose is installed in the wrong position, then the pressure will be low, and when the tire deflates, it will pump out in the wrong direction. So, for example, when installing a tube in the gas pedal, you will pump out the excess pressure, and when the valve opens, you will pump out all the air. The installation of a tube in the gas pedal should be performed as follows : Installation of a tube in the gas pedal The procedure of pumping the nozzle into the tank It is important that the tube is installed only after installing the valve in the gas pedal . After that, the pressure should be kept there, and not decrease. Pumping the nozzle into the tank It is necessary to pump the nozzle before installing the valve in the tank . The reason for pumping The reason for pumping the nozzle into the tank is the diameter difference of the channels for the discharge hose . In the case of a single-channel installation, the reason is obvious – there will be no pressure, and with increasing speeds, the pump will pump out the excess pressure. A broken hose can cause a pressure gauge to fail. If the pressure falls, it will not help to pump the air into the cabin. In a situation where there is no pressure in the cabin, pump it up! How to install a gas pump Install the braid on the gas pedal, and you need to replace it with a control valve. You can only install the valve in the gas pedal, but not in the other direction. It is best to install the valve in the other direction, the arrow on the valve should be installed at the same time as the arrow on the firing valve . Carefully pump the nozzle into the inner tube of the gas pedal. The arrow on the valve should be installed on the valve as the arrow on the firing valve. The arrow on the

Mailing